清空記錄
歷史記錄
取消
清空記錄
歷史記錄
反應釜由釜體、釜蓋、夾套、攪拌器、傳動裝置、軸封裝置、支承等組成。攪拌形式一般有錨式、槳式、渦輪式、推進式或框式等,攪拌裝置在高徑比較大時,可用多層攪拌槳葉,也可根據用戶的要求任意選配。并在釜壁外設置夾套,或在器內設置換熱面,也可通過外循環進行換熱。加熱方式有電加熱、熱水加熱、導熱油循環加熱、遠紅外加熱反應釜、外(內)盤管加熱等,冷卻方式為夾套冷卻和釜內盤管冷卻,攪拌槳葉的形式等。支承座有支承式或耳式支座等。轉速超過160轉以上宜使用齒輪減速機。開孔數量、規格或其它要求可根據用戶要求設計、制作。
The reaction kettle is composed of a kettle body, a kettle cover, a clamping sleeve, an agitator, a driving device, a shaft sealing device, and a support. Mixing in the form of anchor, paddle type, turbine type, propulsion or frame type, etc., mixing device in the high diameter, when you can use multi layer mixing paddle, can also be optional according to user requirements. A jacket is arranged outside the kettle wall, or a heat exchange surface is arranged in the device, and the heat exchange can also be carried out through an outer loop. The heating modes include electric heating, hot water heating, heat conducting oil circulating heating, far infrared heating reactor, outer (inner) coil heating, etc. cooling method is jacket cooling and kettle coil cooling, stirring paddle form and so on. The supporting seat has a support type or an ear type support. Gear reducer shall be used when the speed is over 160 rpm. The quantity, specifications or other requirements of the opening can be designed and manufactured according to user's requirements.
1.通常在常壓或低壓條件下采用填料密封,一般使用壓力小于2公斤。
2.在一般中等壓力或抽真空情況會采用機械密封,一般壓力為負壓或40公斤。
3.在高壓或介質揮發性高得情況下會采用磁力密封,一般反應釜壓力超過14公斤以上。除了磁力密封均采用水降溫外,其他密封形式在超過120度以上會增加冷卻水套。
1. usually under normal or low pressure packing seal, the general use of less than 2 kg pressure.
2. in general medium pressure or vacuum conditions will use mechanical seal, the general pressure is negative pressure or 40 kg.
3., in high pressure or medium volatile high case will use magnetic seal, general reactor pressure more than 14 kilograms. In addition to the magnetic seals are using water cooling, other forms of sealing in more than 120 degrees will increase the cooling water jacket.